Trenchless moling
A new water pipe to your house without digging up the garden. We dig a small pit at each end, and a mole pulls the new pipe through underground, under your lawn, drive and paths.
Rather talk? Ring free on 0800 804 4624
or WhatsApp us a photo.
- No trench across the garden
- Usually done in a day
- Fixed price before we start


What customers say
Rated 4.9 on Google
Swipe for more reviews
What moling saves you
Moling is how most supply pipes are replaced now. Compared with digging a trench the whole way, this is what it means for you.
Your garden stays as it is
No trench across the lawn and no lifted drive. Two holes about the size of a paving slab, filled in and turfed when we finish.
It is usually done in a day
No days of open ground, diggers or mess. Most homes have a new pipe by the end of the day.
It usually costs less
Less digging and less putting back means a smaller bill than a trench for the same length of pipe.
It goes under hard surfaces
Drives, paths, patios and steps stay in place. The pipe goes under them, not through them.
You can stay at home
The water is only off while we connect the new pipe at each end, usually a couple of hours.
A pipe that lasts
We pull through new blue MDPE pipe, which does not rust or corrode.
Which pipe is yours?
Most people only find out when it leaks. The water company looks after the main in the road. The pipe that runs under your garden to the house is your responsibility.
- 1
The main in the road
The water company owns this, and the pipe from it as far as your boundary.
- 2
Your boundary
Usually where the outside stop tap or meter sits. From here in, the pipe is yours.
- 3
Your supply pipe
If it leaks, is made of lead or gives poor pressure, putting it right is down to you. This is the pipe we repair and replace.
- 4
How we replace it
Two small pits and a mole that pulls the new pipe through underground. The lawn and drive stay where they are.
What happens on the day
Step 1
Two small pits
One by your boundary stop tap and one where the pipe goes into the house. That is all the digging.
Step 2
The mole goes in
A torpedo-shaped tool driven by compressed air pushes through the soil from one pit to the other, deep enough to stay clear of frost.
Step 3
The pipe follows
The new pipe is pulled through behind it. The old one stays working until we switch over.
Step 4
Connected, tested, tidied
We connect both ends, pressure test it, fill in the pits and put the turf or paving back.
When moling will not work
A mole needs soil or clay to push through. Solid rock, a lot of large stones, or a tangle of other pipes and cables in the way can stop it. So can a route with lots of bends.
We will tell you at the free visit if we think that is likely. If so, we dig a neat trench instead and put everything back, and you get that price before we start. If the mole hits something on the day, we stop and talk to you before doing anything different.
What it costs
Free visit, then a fixed price in writing
It depends on the length of the run from the boundary to the house, how deep the pipe goes and how easy it is to get to each end. You get a fixed price after a free visit.
More on what changes the price in our cost guide.
Your fixed price includes
- Both pits dug and filled
- New MDPE pipe pulled through
- Connections at both ends
- Pressure testing
- Turf or paving put back
- Dealing with the water company
Over 20 years on supply pipes. From Wokingham we cover Berkshire and the counties around it, west London included. Fully insured.
A fixed price before we start. We look at the job and give you the price in writing. The quote is free and you are under no obligation.
We deal with the water company for you. We work on supply pipes in Thames Water, South East Water and Affinity Water areas and handle their paperwork.
Questions people ask us
How much does moling cost per metre?
We price the whole job rather than per metre, because the pits, the connections and putting the ground back are a big part of the cost whatever the length. You get one fixed price for the whole job after a free visit.
How big are the holes?
About the size of a paving slab or two, one at each end. We fill them in and put the turf or paving back before we leave.
How deep does the pipe go?
At least 750mm below ground, which is the depth water regulations ask for to keep the pipe clear of frost.
Can you mole under my drive?
Yes. That is one of the main reasons to mole. The drive stays as it is and we only dig on either side of it.
What if the mole hits something?
We stop and talk to you. Sometimes we can go round it; sometimes part of the run needs digging. We will not do anything that changes the price without asking you first.
Want to know if moling will work for you?
Tell us where you are and what the pipe runs under. We will come and look, and give you a fixed price for moling, or for a trench if moling will not work.
Other things we can help with
- Leak detectionFind where the supply pipe is leaking before anyone digs.
- Water pipe replacementA new supply pipe from your boundary to the house.
- Lead pipe replacementOld lead out, modern plastic pipe in.
- Open-cut trenchingFor ground a mole cannot get through. Put back as we found it.
- Burst pipe repairsWater coming up through the lawn or drive? Ring us.
- Do I need a new water main?The signs, and what to do about them.
- What it costsWhat changes the price, and how we quote.

